FD RX7 Infinity Ring LED conversion kit

Infinity 99 type Rings

Running lights: The Two inside rings illuminate half brightness // Infinity chambers run with these signals. Turn infinity Chamber runs with Turn signal only

Brakes: The two inside rings illuminate Full Bright

Turn signals: Outer Ring in Amber/Yellow LEDs.

• A load resistor is supplied for those with stock wiring to prevent “hyper-flashing”. Heat is not as big of an issue, but I will not install them for you.
• This design is not to exact sizes as the OEM 99 Spec tails, so I cannot confirm that the 99 Spec tail covers will correctly display the leds.

__________________________________________________________________

---

The Standard kit cost is a DIY price shipped.

We can install the kit for you for at no additional labor cost. We charge a $50 shipping fee to send the tail lights back in this case.

Local installation is an option as well.

The kit includes:
1x Left Tail board
1x Right Tail board
2x Load resistors for Turn Signal Hyper flash fix

DISCLAIMER:
These are not certified by NHTSA and are for off road/Track/Show use only.

__________________________________________________________________

ATTENTION! THESE PRODUCTS ARE MADE TO ORDER. Expect a 2-5 week turn around

Professional grade circuit boards and components designed to withstand the harsh automotive environment.

The circuit boards are made to be an almost plug and play system. Removing the lens is all that is needed to install these. The wiring uses stock bulb sockets so there is no cutting of the harness.

The LED’s will be in a dangerous electrical system which can easily kill unprotected lights. All LED’s have voltage regulated circuits with diode reverse voltage protection.

Brake light brightness is a vital requirement so they use high quality automotive grade LED’s. They can easily be seen during the day even in the bright Arizona sun.

__________________________________________________________________